The clutch cover gasket is non reversible, note which side faces the crankcase and fit all others the same way. i.e. printed or shiny side outermost. The cylinder head gasket has a small hole on its left-hand side to mark its orientation.
Tip - Use an old rocker cover gasket after the head gasket has been replaced, run the engine through at least one hot/cold cycle, re torque the head nuts and then use the new gasket.
A typical gasket kit will contain:-
Qty. Ref. P/No. Description
1 x 8 11394-377-000 Packing, R. crankcase cover
1 x 9 11398-333-020 Gasket, oil pan
1 x 13 11691-333-000 Gasket, dynamo cover
1 x 15 12191-377-000 Packing, cylinder
4 x 19 12209-333-005 Seal, valve stem
1 x 20 12251-377-000 Gasket, cylinder head
1 x 23 12329-333-010 Gasket, breather cover
1 x 25 12391-333-000 Gasket, cylinder head cover
2 x 32 12909-333-000 Gasket, cylinder stud
2 x 33 12910-333-000 Gasket, orifice valve
4 x 57 18291-028-000 Gasket, ex. Pipe
4 x 108 16173-253-004 O-ring, 27x2.4
1 x 201 30372-300-300 Gasket, point cover
8 x 280 91301-200-000 O-ring, 10x1.6
1 x 282 91301-333-000 O-ring, 7x1.7
4 x 283 91301-377-000 O-ring, 55.5x2
8 x 284 91302-001-020 O-ring, 30.8
1 x 288 91305-333-000 O-ring, 5x1.7
A typical Oil seal kit will contain:-
1x271 91201-300-003 Oil seal, 30x42x8
1x272 91201-323-005 Oil seal, 30x45x8
1x273 91201-324-010 Oil seal, 6.5x14.5x7
1x275 91202-216-005 Oil seal, 14x24x5
1x276 91204-259-000 Oil seal, 16x28x7
1x277 91205-333-005 Oil seal, 34x52x13.5x15.5
1x278 91206-286-005 Oil seal, 14x28x7
1x279 91207-333-000 Oil seal, 34x9
Some other gaskets, seals and o-rings will be needed, check before ordering.
See also:-
Pattern v genuine parts